Optimizing The Qpe Start-up Time Options

[peter chen]

Hi,everyone
Recently,i have done something about Optimizing the qpe start-up time,as the start-up time of qpe is so slow for consumer products.
i find it needs to cost half of start-up of time to load plugin(
inputmethod,applet.....).i want to find some ways to load plugin after
UI visible.but i failed.
anyone who did it before,can u give u some tips?
thx in advance

[timematcher]

Hi,everyone
Recently,i have done something about Optimizing the qpe start-up time,as the start-up time of qpe is so slow for consumer products.
i find it needs to cost half of start-up of time to load plugin(
inputmethod,applet.....).i want to find some ways to load plugin after
UI visible.but i failed.
anyone who did it before,can u give u some tips?
thx in advance

Actuallly i havent tried to optimize it the way you are doing but there is another way. Try reducing the size of the executables in the $QPEDIR/bin folder. You can use the "strip" command of the GCC Compiler.

If you have compiled for the ARM architecture then you must use the arm-linux-strip command. Dont use the ordinary strip or it will screw your binaries.

I had 3.0 MB of qpe executable and i striped it down to make it 2.5 MB. Significant change in performance was observed.

As a side note: I think it will be very difficult to optimize the code in the way you suggested. That's because the various components of the main QPE executable is linked with a lot others in a shared manner. You may say: "Shared Dependencies of Components and services".

Anyways if you are succesful in increasing loadind/startup performance of your QPE binary then do post your experiences back.

Thanks