Cacko 1.22 And Navilock Gps Cf Options

[Hakkikkt]

Hoi,
instead of hiding everything in the main Cacko 1.22 thread I deceided to put this remark/solution into a new one.
I finally got my Navilock GPS CF card (SIRF Star II/Low Power chipset) working.
The problem was, that it identified itself as
"CF CARD", "GENERIC", "", ""

This entry is also found in /etc/buetooth/uart and /etc/bluetooth/serial, which are called from /etc/pcmcia/serial
and every time the card was inserted, not only serial_cs.o was loaded, also the blueZ drivers were loaded (and ttyS3 was not accessible).

As I have no need for the bluetooth drivers, I simply renamed /etc/bluetooth/uart and /etc/bluetooth/serial and now everything works fine for me ;-)

And now I am really happy with the new Cacko rom .... great work!
Have fun, Georg

[jacobk]

I had to do one more step and rename /etc/pcmcia/bluetooth.conf (and reboot)

[silvio]

I have two cards - a Haicom 303 MMF and a Belkin Bluetooth Card.
Both of them identifies themself as shown:

CODE

cardctl ident
Socket 0:
 product info: "CF CARD", "GENERIC", "", ""
 manfid: 0x0279, 0x950b
 function: 2 (serial)

I need Bluetooth and GPS. Is there a way to help the system detecting the cards?
Or is there a way to shutdown bluetooth without reboot?

regards,
Silvio

[silvio]

I have two cards - a Haicom 303 MMF and a Belkin Bluetooth Card.
Both of them identifies themself as shown:

CODE

cardctl ident
Socket 0:
 product info: "CF CARD", "GENERIC", "", ""
 manfid: 0x0279, 0x950b
 function: 2 (serial)

I need Bluetooth and GPS. Is there a way to help the system detecting the cards?
Or is there a way to shutdown bluetooth without reboot?

regards,
Silvio

Now I have renamed to 3 files and did a reboot - but it seems there comes no data from the device (/dev/ttyS3). gpsd starts without errors, but qpeQGP and zgps doesn't show anything.

[silvio]

Now I got GPS and Bluetooth working with Cacko ROM.

This workarround should work with every GPS card which identifies itself as "CF CARD", "GENERIC". Use cardctl ident to check this.

1. According to this message you may need another serial_cs driver:
http://www.iral.com:88/~albertr/zaurus/misc/serial_cs.o.gz

2. Open the file /etc/bluetooth/serial with an editor, locate the line that starts with "CF CARD", "GENERIC". Append spd_cust divisor 24 at the end of this line.

3. In your GPS software use 38400 for the gpsd baud rate

Now GPS and Bluetooth cards are usable.

The side effect of this trick is, that you can't use your bluetooth card with 38400 baud.

regards,
Silvio