Pcnet_cs Driver Needed For Trendnet Te-cf100 Options

[MB Zaurus]

Hello,

I've got a TRENDnet TE-CF100 wired ethernet card that I'm trying to use on my SL-6000, with the original Sharp ROM and kernel version 2.4.18-rmk7-pxa3-embedix. I believe that I need the pcnet_cs.o kernel module, compiled for this kernel.


I've used this card on the same Zaurus under OE, but the pcnet_cs.o driver seems to be missing from the Sharp ROM distribution. I've added an entry to /etc/pcmcia/config, and the card is recognized, but it's not usable:

CODE

# cardctl ident
Socket 0:
 product info: "Fast Ethernet", "CF Size PC Card", "1.0"
 manfid: 0x0149, 0xc1ab
 function: 6 (network)

# cardctl status
Socket 0:
 3.3V 16-bit PC Card [suspended]

# ifconfig eth0
eth0      Link encap:Ethernet  HWaddr 00:E0:98:F5:18:4D
         BROADCAST MULTICAST  MTU:1500  Metric:1
         RX packets:0 errors:0 dropped:0 overruns:0 frame:0
         TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
         collisions:0 txqueuelen:100
         RX bytes:0 (0.0 b)  TX bytes:0 (0.0 b)
         Interrupt:43 Base address:0x300

# ifconfig eth0 192.168.1.1 netmask 255.255.255.0 up
SIOCSIFFLAGS: No such device
SIOCSIFFLAGS: No such device

#dmesg
eth0: NE2000 (DL10022 rev 05): io 0xf6000300, irq 43, hw_addr 00:E0:98:F5:18:4D
pxa_pcmcia_suspend(0)
pxa_pcmcia_init(0)

Any suggestions?

Thanks,

Mark

[maslovsky]

Did you try cardctl resume?

[maslovsky]

Also, why don't you use Network Setup to configure network connection?