 C1000 Cross-compiler Setup... |
  |
 May 12 2005, 07:09 AM
Post
#1
|
|
 Group: Members Posts: 298 Joined: 27-October 03 From: Greenfield, NH Member No.: 781  |
- I've finally gotten an usable (as in new enough hardware for noticable performance) Linux installation so I can set up for compilation for the C1000. I have an old (glacially slow) Linux setup for compiling for the SL-5500. If I use the same setup (install files, environment, configuration, etc) I used for the SL-5500, will it work on the C1000? It doesn't *seem* like it should.
- I searched this forum for "C1000" and found not a single post. So I searched the parent for "C1000" and found one post, but that guy appears to be doing local compilation (directly on the Z) instead of cross-compiling on Linux. It may be in another forum, but "Everything Development" sure seemed like the obvious place to look!! (cheshire grin) - Any clues out there? Thanks for your time... |
 |
 
|
|
May 12 2005, 08:45 AM
Post
#2
|
|
 Group: Members Posts: 657 Joined: 29-September 04 Member No.: 4,809 |
It's all still Qtopia 1.5.4, so your old environment should still work. I've use the old tools and instructions to compile for the 860...
|
|
|
|
|
May 13 2005, 08:27 AM
Post
#3
|
|
|
Group: Members Posts: 298 Joined: 27-October 03 From: Greenfield, NH Member No.: 781 |
- Wouldn't the virtual framebuffer geometry be wrong? Or is that configurable? Guess I should try it and see, huh? (drool) The other hardware is soooooo sllllooooowwww that I haven't touched it in months and months.
- Basically just trolling for caveats and whatnot. Thanks for your time... |
|
|
|
|
May 13 2005, 01:51 PM
Post
#4
|
|
 Group: Members Posts: 451 Joined: 27-November 03 From: Brisbane, Australia Member No.: 1,001 |
QUOTE(Ragnorok @ May 14 2005, 02:27 AM) - Wouldn't the virtual framebuffer geometry be wrong? Or is that configurable? Guess I should try it and see, huh? (drool) The other hardware is soooooo sllllooooowwww that I haven't touched it in months and months. - Basically just trolling for caveats and whatnot. Thanks for your time...  Qtopia.net |
|
|
|
|
May 13 2005, 05:06 PM
Post
#5
|
|
|
Group: Members Posts: 298 Joined: 27-October 03 From: Greenfield, NH Member No.: 781 |
- Thanks for the hand holding! Shouldn't have *needed* it, but thanks!
|
|
|
|
|
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 21st May 2013 - 02:54 AM |