OESF | ELSI | pdaXrom | OpenZaurus | Zaurus Themes | Community Links | Ibiblio

IPB

Welcome Guest ( Log In | Register )

 
Reply to this topicStart new topic
> Battery 3.7v Vs 4.2v, battery 3.7V vs 4.2V
wimng
post Dec 2 2004, 11:07 AM
Post #1





Group: Members
Posts: 1
Joined: 7-November 04
Member No.: 5,375



My new C860 is having the notorious 'battery recharge problem' (I hope;).
Currently at 1.5V or something, I was thinking of charging it externally with a custom setup to full charge, and then reflash the voltage level in the DM menu.
Now, I've read in several posts that the reading of a fully charged battery should be 4.2V, while there's 3.7V indicated on the battery pack. 0.5V seems like quite a difference to me. Or am I mixing things up here? Anyone can clear this up for me?
Go to the top of the page
 
+Quote Post
mspencer
post Dec 4 2004, 08:33 PM
Post #2





Group: Members
Posts: 18
Joined: 2-April 04
From: Council Bluffs, Iowa
Member No.: 2,634



This is normal. 3.7v is the "nominal" voltage -- this is the voltage your battery will spend most of its life at. 4.2v for an unloaded 3.7v battery is perfectly normal. (Just as a 12v car battery can be measured at 13v or more soon after being charged)

--Michael Spencer
Go to the top of the page
 
+Quote Post
omega
post Dec 6 2004, 05:13 AM
Post #3





Group: Members
Posts: 626
Joined: 13-April 04
From: Ireland
Member No.: 2,825



mspencer is correct, 1.5volts sounds dangerously low... if you discharge batteries too deeply they may not recover. Be very careful charging the battery externally... if you don't know what you're doing you could fry your battery or reduce it's life...

My suggestion (take it at face value) is to use a 5v power supply and a 5ohm 3 watt resistor in series to charge the battery for 1 hour only. This will give you enough juice to set the menu options and let your battery charge in the Z properly. This will definitely not harm your battery using the value of resistor shown, and is cheap.
Go to the top of the page
 
+Quote Post
Miami_Bob
post Dec 6 2004, 01:46 PM
Post #4





Group: Members
Posts: 483
Joined: 10-April 04
From: Miami FL
Member No.: 2,781



If you check some of the older battery threads, you will find that the "third" (center) terminal on the battery connects to an internal thermistor that is used by tje Z & external chargers to regulate the charging current and keep from frying the internal battery electronics.

This is NOT a simple battery like an "AA" cell! You have circuitry inside that can be damaged by overcharge, heat, reverse polarity & such. Proceed with reasonable caution.
Go to the top of the page
 
+Quote Post

Reply to this topicStart new topic
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:

 



RSS Lo-Fi Version Time is now: 20th April 2014 - 08:36 PM