OESF | ELSI | pdaXrom | OpenZaurus | Zaurus Themes | Community Links | Ibiblio

IPB

Welcome Guest ( Log In | Register )

 
Reply to this topicStart new topic
> Usb For 2.6 Kernel On Poodle, How to get g_ether to talk to windows
hvontres
post Jul 29 2006, 06:14 PM
Post #1





Group: Members
Posts: 118
Joined: 12-May 05
From: Oceanside,Ca
Member No.: 7,121



The 2.6 kernel uses the g_ether driver for usb networking now. First, make sure to run
CODE
modprobe g_ether
ifup usb0


That should bring up your interface on the Z. Note that it is now usb0 and no longer usbd0. Next, follow the instructions on this site to get the windows driver installed:
http://www.handhelds.org/moin/moin.cgi/Win...UsbNetworkHowTo

you may need to remove the old sharp drivers in order to get internet connection sharing to work. I use this setup to get my Z online when I am at work smile.gif
(Just don't tell my IT guys.. wink.gif )
Go to the top of the page
 
+Quote Post

Reply to this topicStart new topic
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:

 



RSS Lo-Fi Version Time is now: 21st October 2014 - 12:00 PM