 [help]c1000 Always Restarts, Usb Problem |
OESF Forums > Distros, Development, and Model Specific Forums > Model Specific Forums > C1000/3x00 General discussions  |
  May 9 2005, 08:12 AM
Post
#1
|
|
|
Group: Members Posts: 15 Joined: 28-April 05 Member No.: 7,020  |
I'm using a Zaurus C1000. I've set the C1k's "PC Link" mode to "Storage->SD Card", and it used to work well.
But today, while I'm plugging the usb cable in, the Zaurus restarts to the "CG Silicon" picture. Just leave a quick prompt like "Can't locate block-major-3". And I tried several times, there's always the same scene. Does any one can help me to solve this problem? Thanx. |
 |
 
|
|
May 9 2005, 10:09 AM
Post
#2
|
|
 Group: Members Posts: 657 Joined: 29-September 04 Member No.: 4,809 |
Well, the CG-Silicon screen means a full reboot of the Z, not just a Qtopia crash. You're probably looking at a hardware issue. Have you tried hooking up to USB on another computer or port, trying another cable, etc? What happens when you set PC link to its regular setting, not storage mode?
|
|
|
|
|
May 9 2005, 05:31 PM
Post
#3
|
|
|
Group: Members Posts: 15 Joined: 28-April 05 Member No.: 7,020 |
QUOTE(kahm @ May 10 2005, 02:09 AM) Well, the CG-Silicon screen means a full reboot of the Z, not just a Qtopia crash. You're probably looking at a hardware issue. Have you tried hooking up to USB on another computer or port, trying another cable, etc? What happens when you set PC link to its regular setting, not storage mode?  Ugh... I've tried on different computers, and different usb cable, but it still shows "CG-Silicon" screen. BTW, while it's rebooting(showing the image), i can operate my SD card from the PC side just as old times, the only difference is there's always a "CG-Silicon" on the zaurus, and the system runs "time setting" program after I pull the usb cable out. When I set PC link to "USB TCP/IP" mode, everything goes fine, and I can see and operate "\\zaurus" with my browser, but it's too slow. Maybe it's my fault to pull out my sd card while it's reading/writing? I'm not very sure. :-( |
|
|
|
|
May 9 2005, 06:43 PM
Post
#4
|
|
|
Group: Members Posts: 15 Joined: 28-April 05 Member No.: 7,020 |
I think I found the reason.
I searched the programs I installed most recently, and uninstalled the "qpealarmclock", and zaurus works well now. |
|
|
|
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 19th May 2013 - 01:57 PM |