OESF Portal | OESF Forum | OESF Wiki | LinuxPDA | ELSI (coming soon) | Ibiblio


Welcome Guest ( Log In | Register )

Reply to this topicStart new topic
> Avoiding Issues With Surface Mount Soldering, use silver conductive paint!
post Jan 26 2006, 03:19 PM
Post #1

Group: Admin
Posts: 3,364
Joined: 29-July 04
From: Cambridge, England
Member No.: 4,149

see this thread:

where someone successfully repaired a blown fuse in his Z using silver paint so as to avoid soldering! This would be a really safe way to install a bluetooth module in a 6000!
Go to the top of the page
+Quote Post
post Jan 27 2006, 01:54 AM
Post #2

Group: Members
Posts: 227
Joined: 26-October 05
Member No.: 8,405

It's not so easy. The conducting paint has a very short working time before it gets to setting on you. It has no physical strength when dry and it has a significant impedance compared to a soldered joint. Also, for the first few hours after application it has a high impedance, too high for todays electronics.

I use it a lot for mending ribbon cable (the sort that connects a screen to a laptop) but as a replacement for soldering it's not really up to it.
Go to the top of the page
+Quote Post
post Jan 28 2006, 06:50 PM
Post #3

Group: Members
Posts: 1,565
Joined: 7-April 05
From: Sydney, Australia
Member No.: 6,806

Bypassing a fuse is not normally a good idea as it is there to prevent damadge, and if the fault hasent been fixed then you can say good bye to your hardware

back to the topic, soldering isnt very hard to do, and you could probelly find someone to do it for you if you dont feel like investing the time and money, as for safty there is no way i would consider this to be "safe", even if the alternative is jabbing a 100W soldering iorn into the guts of your PDA
Go to the top of the page
+Quote Post

Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:


RSS Lo-Fi Version Time is now: 19th October 2017 - 12:18 PM