OESF | ELSI | pdaXrom | OpenZaurus | Zaurus Themes | Community Links | Ibiblio

IPB

Welcome Guest ( Log In | Register )

> Installing What Is Built, How are the blah-image.tar.gz installed?
adf
post Apr 3 2005, 01:06 PM
Post #1





Group: Members
Posts: 2,821
Joined: 13-September 04
From: Wasilla Ak.
Member No.: 4,572



I guess this sounds kinda dim.... but:
I have no idea how to install an image I build on OE on my 6000. ( I made the topic broader so as to give an opportunity for per model bullet points in a final post--in case it isn't just me)

Is the file to be renamed? what updater should be used? what file structure in the card used to flash?

I have searced the wilki, asked a few people over the winter and searched the forums. I honestly cannot find a clear useable answer to this.

something along the lines of:
rename "blah.tar.gz" "blahbin"
put it on the flash card with "this updater" from "here"
include the following files from "here" in the following arrangement (if necessary)
flash with the following buttons

It is very hard to check out stuff I can't install..as you might imagine smile.gif
Go to the top of the page
 
+Quote Post
 
Start new topic
Replies
lardman
post May 17 2005, 01:24 PM
Post #2





Group: Members
Posts: 4,515
Joined: 25-October 03
From: Bath, UK
Member No.: 464



http://openzaurus.org/wordpress/installation/sl-6000/

You should have to flash image files which are identically named but for the extension - jffs2 and bz2 iirc.

Use the jffs2 one and rename it to initrd.bin, rename the zimage-*.bin to zImage.bin, grab the updater from the 6000 ROM dir on oz.org (http://www.openzaurus.org/official/unstable/3.5.2/sl6000/), flash.


Si
Go to the top of the page
 
+Quote Post

Posts in this topic


Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 



RSS Lo-Fi Version Time is now: 20th December 2014 - 08:32 AM