OESF | ELSI | pdaXrom | OpenZaurus | Zaurus Themes | Community Links | Ibiblio

IPB

Welcome Guest ( Log In | Register )

> C760 Charging Problem, Problem was a Loose Conector on Z
jmcneill
post Dec 29 2005, 06:42 PM
Post #1





Group: Members
Posts: 30
Joined: 29-July 03
From: Michigan
Member No.: 314



My Z took to NOT charging. Sometimes the charge light would be on and sometimes not, either way battery would not charge in C760. Same battery would charge in 5500 after cutting nose off to do a charge test. After MUCH looking I found that power connection on C760 was very slightly loose on the inside back. Tacking case apart I found that the inside lead on the back of the connector was not solidered in very well and the solider had come loose from the wire. This could only be seen on the underside of the board (held in place by four black flat head screws on my unit) as that is the side which is solidered. Used SMALL iron and a VERY TINY amount of additional solider and my C760 now works JUST LIKE NEW. This post is just a hint of direction for others who can pinpoint that they have the same problem however BE VERY CAREFUL if you attempt the same fix as these boards are VERY easily damaged with either too much HEAT or SOLIDER, use care and proceed AT YOUR OWN RISK.
biggrin.gif
Go to the top of the page
 
+Quote Post

Posts in this topic


Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 



RSS Lo-Fi Version Time is now: 16th September 2014 - 07:37 PM