Question Abt. Japanese Page Re Bluetooth Mod Options

[daniel3000]

Hi huys.

I'm considering to upgrade my Zauri with USB Bluetooth modules.
Since I want to keep the hardware compatible with standard kernels and don't want to do too many modifications to the hardware, I'm looking into the simple solution:
Take a normal USB BT module, connect it 1:1 to the USB port with a power switch, which will probably be blocking the USB port when BT is used. This limitation is okay with me.

I think this method is described here:
http://www.piro.hopto.org/~piro/pukiwiki/p...%A2%B2%BD%5D%5D

But since I cannot read any Japanese, would anyone able to read that please let me know how the switch must be connected?
From the pics it seems the switch only switches one line. But which one?
Is it really enough to switch only one line (probably one of the power lines)?
When the data lines are still co nnected to the BT module, can other USB devices which are attached in a normal way to the USB port still work without a problem?


Once I know all this, I will begin with the surgery and take some better pictures to put them onlilne.
I think this is a great way of enhancing the functionality of a Zaurus!

aTdHvAaNnKcSe
daniel

[pelrun]

You need to switch two lines with a dual-pole (DPDT or DPST) switch. I suggest one pole goes between GND on the Z and GND on the module, and the other goes between GND on the Z and the ID pin in the Z's usb port. Which is next to the GND pin, btw.

If you were to permanently connect the ID pin to ground you would force the Z's usb port to always be in host mode, which will use more power even when nothing is connected.

[daniel3000]

You need to switch two lines with a dual-pole (DPDT or DPST) switch. I suggest one pole goes between GND on the Z and GND on the module, and the other goes between GND on the Z and the ID pin in the Z's usb port. Which is next to the GND pin, btw.

If you were to permanently connect the ID pin to ground you would force the Z's usb port to always be in host mode, which will use more power even when nothing is connected.

aha thanks...
so then comes to mind:
Wouldn't it be enough to wire the ID pin directly to ground on the module and only switch GND of the Z to GND of the module? That way the switch would interrupt module power AND the ID-GND-connection with just one pin...

Is there any picture or schematic where I can see the pin assignment of the Z USB port (backside, where I can solder)?
Can I solder directly to the legs on the back of the connector?

thanks
daniel