 Hentges Akita Installation Fails (abandoned), The Japanese boot menu does nothing |
OESF Forums > Distros, Development, and Model Specific Forums > Distro Support and Discussion > Angstrom & OpenZaurus
 Jun 17 2007, 11:59 PM
Post
#1
|
|
|
Group: Members Posts: 120 Joined: 14-June 06 Member No.: 10,168  |
When holding 'ON' to perform the flash update with the correct files on my SD card, and choosing option 4 and selecting my SD card, I get an 'ok' prompt in Japanese.
It's acting as though it doesn't see the card. These are the files I've used: http://hentges.net/tmp/snapshots/Hentges-R...kita/updater.sh http://hentges.net/tmp/snapshots/Hentges-R...20061108.tar.gz http://hentges.net/tmp/snapshots/Hentges-R...61108024133.bin I have properly renamed the images. I had to take the updater.sh from a previous version because it did not exist for the current version. I have performed a complete NAND restore from my original file and have booted into it to confirm that it works. The SD device is detected and works as usual. It's FAT16 and has been previously used for image installation. So what can I do to install this image? Nothing I've done works.. |
 |
 
|
Posts in this topic
Sy Ali Hentges Akita Installation Fails (abandoned) Jun 17 2007, 11:59 PM
rolf your best bet is to write to the angstrom user mai... Jun 30 2007, 01:23 AM Sy Ali I'm confused.
Angstron = Hentges? Jun 30 2007, 08:18 AM rolf Well, I am sorry. I should have read more careful... Jun 30 2007, 09:21 AM
Sy Ali I was hoping Hentges was just a quiet project like... Jun 30 2007, 11:13 AM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 19th May 2013 - 01:51 PM |