 Nmap Not Working. |
 Oct 14 2007, 09:17 AM
Post
#1
|
|
 Group: Members Posts: 2,350 Joined: 30-July 06 Member No.: 10,575  |
When I try to run nmap on my Zaurus (pdaX r198, Ambicom WL1100C wireless, custom-built pcap), it says
CODE Starting Nmap 4.20 ( http://insecure.org ) at 2007-10-14 12:14 UTC pcap_open_live(wlan0, 104, 0, 200) FAILED. Reported error: live packet capture not supported on this system. Will wait 5 seconds then retry. caught SIGINT signal, cleaning up What causes this? Kismet works fine. Do I need to put the card into monitor mode or something (it's just connected to my wireless now). Thanks. |
 |
 
|
Posts in this topic
Capn_Fish Nmap Not Working. Oct 14 2007, 09:17 AM
Capn_Fish Nobody? Or is this just that obvious? Oct 16 2007, 02:18 PM sdjf You could try running strace and study the output ... Oct 22 2007, 08:15 AM Capn_Fish It's not hanging just giving an error (as seen... Oct 22 2007, 10:24 AM sdjf Uh, well did you try strace if it helped you figur... Oct 22 2007, 11:49 PM sdjf Look at this:
http://www.oesf.org/forum/lofiversi... Oct 23 2007, 12:00 AM Capn_Fish OK, that error was because I forgot to install pca... Oct 23 2007, 03:51 AM sdjf Is it the identical "live packet capture... Oct 24 2007, 06:35 AM Capn_Fish I think it's the same error, and I'll try ... Oct 24 2007, 05:05 PM
sdjf Strace could take the guesswork out of what's ... Nov 1 2007, 05:04 AM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 22nd May 2013 - 03:14 PM |