 Nmap Not Working. |
 Oct 14 2007, 09:17 AM
Post
#1
|
|
 Group: Members Posts: 2,350 Joined: 30-July 06 Member No.: 10,575  |
When I try to run nmap on my Zaurus (pdaX r198, Ambicom WL1100C wireless, custom-built pcap), it says
CODE Starting Nmap 4.20 ( http://insecure.org ) at 2007-10-14 12:14 UTC pcap_open_live(wlan0, 104, 0, 200) FAILED. Reported error: live packet capture not supported on this system. Will wait 5 seconds then retry. caught SIGINT signal, cleaning up What causes this? Kismet works fine. Do I need to put the card into monitor mode or something (it's just connected to my wireless now). Thanks. |
 |
 
|
 |
Replies
|
Oct 24 2007, 05:05 PM
Post
#2
|
|
|
Group: Members Posts: 2,350 Joined: 30-July 06 Member No.: 10,575 |
I think it's the same error, and I'll try strace.
One thing that came up was recompiling the kernel with something or other enabled, but I'll hold off on that for at least a bit. |
|
|
|
Posts in this topic
Capn_Fish Nmap Not Working. Oct 14 2007, 09:17 AM
Capn_Fish Nobody? Or is this just that obvious? Oct 16 2007, 02:18 PM sdjf You could try running strace and study the output ... Oct 22 2007, 08:15 AM Capn_Fish It's not hanging just giving an error (as seen... Oct 22 2007, 10:24 AM sdjf Uh, well did you try strace if it helped you figur... Oct 22 2007, 11:49 PM sdjf Look at this:
http://www.oesf.org/forum/lofiversi... Oct 23 2007, 12:00 AM Capn_Fish OK, that error was because I forgot to install pca... Oct 23 2007, 03:51 AM sdjf Is it the identical "live packet capture... Oct 24 2007, 06:35 AM
sdjf Strace could take the guesswork out of what's ... Nov 1 2007, 05:04 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
|
Lo-Fi Version | Time is now: 19th June 2013 - 01:31 PM |