OESF | ELSI | pdaXrom | OpenZaurus | Zaurus Themes | Community Links | Ibiblio

IPB

Welcome Guest ( Log In | Register )

> Pimp Your Zaurus: 1gbyte Nand Flash Upgrade, ...first seen on my Zaurus C750 ;)
ranma
post Jun 15 2008, 03:59 AM
Post #1





Group: Members
Posts: 5
Joined: 13-October 07
Member No.: 20,818



Hi all!

I recently looked into how the NAND is hooked up on the Zaurus (my C750):

CODE
          TP6
            TP5
          TP4
---------   TP3
|Xilinx | TP2
|CPLD   |   TP1
|       |
---------


TP1 => CE0
TP2 => CE1! (unused?)
TP3 => /WP
TP4 => /WE
TP5 => ALE
TP6 => CLE

I also found two nicely compatible 8GBit TSOP48 Toshiba Flash Chips in a CNMemory 2GByte CF Card.

So I soldered one of the 8GBit chips on top of the already existing 512MBit chip (all signals except CE are shared).
Soldering was a bitch though (pins did almost, but not quite reach the pins below), but with lots of solder, cursing, solderwick and patience
I eventually had all relevant pins connected. smile.gif
Since the Linux kernel unfortunately always enables/disables both CE signals I couldn't simply use the CE1 signal from the CPLD, but for now
(first tests) I hooked up CE to the Cathode of the Green EMail-LED (which is normally always off and the transistor acts as an inverter, so
'on' == low, exactly what I need) and a 10k pull-up.

The system boots fine and a hacked up 'fiddle with CEs and read IDs' kernel module finds both Chips just fine:
CODE
Trying to read id from Flash on CE0
Got maker=98 device=76
Trying to read id from Flash on CE1|GreenLED
Got maker=98 device=d3


According to drivers/mtd/nand/nand_ids.c maker 0x98 is 'Toshiba', device 0x76 is a 'NAND 64MiB 3,3V 8-bit' and
device 0xd3 is the shiny new 'NAND 1GiB 3,3V 8-bit' (Yay!).

This should actually already exercise all control signals, so the only remaining task is to modify the built-in sharp_sl nand driver to properly support two chips. smile.gif
Go to the top of the page
 
+Quote Post
 
Start new topic
Replies
the_oak
post Jul 13 2008, 05:28 AM
Post #2





Group: Members
Posts: 426
Joined: 10-February 04
From: Virginia, USA
Member No.: 1,794



Keep up the good work. We'll be waiting to hear of future developments.
Go to the top of the page
 
+Quote Post

Posts in this topic


Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 



RSS Lo-Fi Version Time is now: 17th December 2014 - 11:56 AM