![]() |
![]() |
![]()
Post
#1
|
|
![]() Group: Members Posts: 1,853 Joined: 31-December 05 From: Illinois USA Member No.: 8,821 ![]() |
I've been installing Angstrom on my C3100 all day today, and finally got Cacko to dual boot with Angstrom, following these instructions:
http://www.linuxtogo.org/gowiki/AngstromAndCacko The above instructions worked fine, but my problem is with the instructions below, in the part where you repartition the HDD. When in a console in Cacko, my partitions add up to only 140M, 46M, and 1022M (That's roughly 1.2GB) I get the same results as above in a console in Angstrom also. Where did the other 2.8GB go?? http://www.angstrom-distribution.org/angst...tallation-spitz CODE As root in a console do the following:
# fdisk /dev/hda Command (m for help): o (Blow away the partition table) Command (m for help): n (New partition) Partition type: p (Primary partition [1-4]) Partition number (1-4): 1 (Root partition) First cylinder (1-7936, default 1): 1 (Start of disk) Last cylinder or size: +150M (150 Mbyte, adjust as desired) Command (m for help): n (New partition) Partition type: p (Primary partition [1-4]) Partition number (1-4): 2 (Home partition) First cylinder (293-7936, default 293): [hit enter] (Just after hda1) Last cylinder or size: +40M (40 Mbyte, adjust as desired) Command (m for help): n (New partition) Partition type: p (Primary partition [1-4]) Partition number (1-4): 3 (Root partition) First cylinder (372-7936, default 372): [hit enter] (Just after hda2) Last cylinder or size: [hit enter] (Rest of disk) Command (m for help): w (Write to disk) |
|
|
![]() |
![]()
Post
#2
|
|
![]() Group: Members Posts: 1,853 Joined: 31-December 05 From: Illinois USA Member No.: 8,821 ![]() |
I did try fsk.vfat -F 32 /dev/hda3
again and did the fsck.vfat -a -f -t -v -V It remained the same. I would like to make a swap drive sometime in the future, but was waiting until I can get this sorted out I'm scared if I try fdisk, i'll blow away my other 2 partitions with angstrom installed to it. |
|
|
![]() ![]() |
![]() |
Lo-Fi Version | Time is now: 21st April 2018 - 10:47 PM |