![]() |
![]() |
![]()
Post
#1
|
|
![]() Group: Members Posts: 48 Joined: 18-February 09 Member No.: 31,414 ![]() |
Hello friends, i have one C3000 and would like make one question to you,
how can i "make" charging the battery from the service menu (d+m)¿? in page 2 there are 2 batt options 5. Low Battery 6.Batt Voltage Adjust 6.1 Battery Voltage Adj 6.2 Battery Voltage Check and a charge option 10. Charge how can i force batt charging thanks in advance!! |
|
|
![]() |
![]()
Post
#2
|
|
![]() Group: Members Posts: 48 Joined: 18-February 09 Member No.: 31,414 ![]() |
|
|
|
![]()
Post
#3
|
|
Group: Members Posts: 135 Joined: 27-June 05 From: Prague, Czech Republic, Europe Member No.: 7,468 ![]() |
be warned that overcharging your battery can damage it permanently; severely overcharging it can make it explode! Ok, but then, what do you recomend for fully charging the battery? Thanks in advance. Boot, plug the external power supply and don't care. Internal charging electronics should be smart enough to prevent explosion. Orange LED is just an indicator, that charging IC is still active. Note: Reading the charger IC datasheet, I considered not being exact while describing charge cycle: When the battery is deeply discharged (below 2.8V), slow charging (pre-charge) is used as well. When the battery reaches 2.8V, fast charge is enabled, when full charge is detected, it goes back to slow charging (termination current). CPU may externally terminate charge cycle. See the datasheet on my Zaurus web pages. |
|
|
![]() ![]() |
![]() |
Lo-Fi Version | Time is now: 19th April 2018 - 03:37 PM |