Mplayer plays movie in a small screen on SL-6000L

I installed MPlayer .90pre10 with ogg vorbis support.

No matter what settings I try to make the screen bigger it always plays in the upper left hand corner of my Z. I have thought of trying to recompile mplayer with tremor support (for ogg vorbis) but not sure where to look to have it not stick in the upper left hand corner all the time.

Any ideas where to start looking or forums to browse?

Thanks

5600 wont recognize sd card.

It used to read it but now it wont. It is a Sandisk 64mb SD card.

This is the output of dmesg

VFS: Disk change detected on device mmcd(60,1)
mmcda:SD read CRC error
sd_read_multiple(1) : receive error
mmc read checked internalbuf: ERROR adr = 0 (0x0) , len = 1024 (0x400)
[SD]-R 0000 0400 ERROR!
pxa_sd_receive_chars: wait full FIFO time out (cmd=18 block=49[32k])
sd_read_multiple(1) : receive error
mmc read checked internalbuf: ERROR adr = 1024 (0x400) , len = 1024 (0x400)
[SD]-R 0400 0400 ERROR!
SD read CRC error
sd_read_multiple(1) : receive error
mmc read checked internalbuf: ERROR adr = 0 (0x0) , len = 1024 (0x400)
[SD]-R 0000 0400 ERROR!
pxa_sd_receive_chars: wait full FIFO time out (cmd=18 block=43[32k])
sd_read_multiple(1) : receive error
mmc read checked internalbuf: ERROR adr = 1024 (0x400) , len = 1024 (0x400)
[SD]-R 0400 0400 ERROR!
unable to read partition table
VFS: Disk change detected on device mmcd(60,1)
mmcda:SD read CRC error
sd_read_multiple(1) : receive error
mmc read checked internalbuf: ERROR adr = 0 (0x0) , len = 1024 (0x400)
[SD]-R 0000 0400 ERROR!
pxa_sd_receive_chars: wait full FIFO time out (cmd=18 block=49[32k])
sd_read_multiple(1) : receive error
mmc read checked internalbuf: ERROR adr = 1024 (0x400) , len = 1024 (0x400)
[SD]-R 0400 0400 ERROR!
SD read CRC error
sd_read_multiple(1) : receive error
mmc read checked internalbuf: ERROR adr = 0 (0x0) , len = 1024 (0x400)
[SD]-R 0000 0400 ERROR!
pxa_sd_receive_chars: wait full FIFO time out (cmd=18 block=42[32k])
sd_read_multiple(1) : receive error
mmc read checked internalbuf: ERROR adr = 1024 (0x400) , len = 1024 (0x400)
[SD]-R 0400 0400 ERROR!
unable to read partition table
jffs2: attempt to mount non-MTD device 3c:01


I tried reformatting and repartitioning without any success. I have no problems using this card in my 6000L.

Any ideas on what to try next?

Zynergy5600 question

Does the Zynergy Rom require a different updater.sh than what comes with the Sharp stock Roms?

If so where do I get it? It wasn't included in the package from Zynergy.

I tried installing the Zynergy Rom and it appeared to install but after I do the reset a second time to format it just sits on the Sharp screen with a blinking cursor.