Help - Search - Members - Calendar
Full Version: Wlan
OESF Forums > Distros, Development, and Model Specific Forums > Distro Support and Discussion > Guylhem Rom
gfdsa
hm, how should internal prism be started ?
guylhem
use usbctl
jbruno
QUOTE(guylhem @ May 6 2005, 10:53 AM)
use usbctl
*


I tried "usbctl on 1" and saw the light on my 6K turn on, but I can't figure out how to get it to connect to my LAN (which has WEP configured). I tried to use the Settings/Internet utility to define a "Service" for my lan, but cannot figure ouit how to get it to start the service.

If I try "/etc/ini.d/wlan start", it says modprobe fail trying to find wlan0.

Is there a LAN setup howto for this ROM somewhere?
g3n
QUOTE(jbruno @ Sep 11 2005, 07:52 PM)
QUOTE(guylhem @ May 6 2005, 10:53 AM)
use usbctl
*


I tried "usbctl on 1" and saw the light on my 6K turn on, but I can't figure out how to get it to connect to my LAN (which has WEP configured). I tried to use the Settings/Internet utility to define a "Service" for my lan, but cannot figure ouit how to get it to start the service.

If I try "/etc/ini.d/wlan start", it says modprobe fail trying to find wlan0.

Is there a LAN setup howto for this ROM somewhere?
*


I have this same problem. i dont know where to start looking
/etc/rc.d/init.d/wlan start says /sbin/wlanctl-ng not found
i can see the light on when start the usbctl
This is a "lo-fi" version of our main content. To view the full version with more information, formatting and images, please click here.
Invision Power Board © 2001-2014 Invision Power Services, Inc.