I saw this in my email this morning:
This patchset adds initial pinctrl support for Mediatek MT6797 SoC.
The pinctrl driver is based on the vendor binding as like MT6765 and
implements only GPIO and pinmux functionalities.

The devicetree binding document consists of pinmux, pinconf and
interrupt functionalities documented since the binding should describe
what the hardware is capable of rather than what the driver offers.

This patchset has been tested on 96Boards MediatekX20 development board.


Changes in v2:

* Added devicetree bindings for Pin Controller
* Dropped the applied warning fix patch
* Added Tested-by tag from Matthias Brugger
* Added Acked-by tag from Sean Wang

Manivannan Sadhasivam (4):
dt-bindings: pinctrl: Add devicetree bindings for MT6797 SoC Pinctrl
arm64: dts: mediatek: mt6797: Add pinctrl support
arm64: dts: mediatek: x20: Add pinmux support for UART1
pinctrl: mediatek: Add initial pinctrl driver for MT6797 SoC

.../bindings/pinctrl/pinctrl-mt6797.txt       |   74 +
.../boot/dts/mediatek/mt6797-x20-dev.dts      |    2 +
arch/arm64/boot/dts/mediatek/mt6797.dtsi      |   21 +
drivers/pinctrl/mediatek/Kconfig              |    7 +
drivers/pinctrl/mediatek/Makefile             |    1 +
drivers/pinctrl/mediatek/pinctrl-mt6797.c     |   82 +
drivers/pinctrl/mediatek/pinctrl-mtk-mt6797.h | 2430 +++++++++++++++++
include/dt-bindings/pinctrl/mt6797-pinfunc.h  | 1368 ++++++++++
8 files changed, 3985 insertions(+)
create mode 100644 Documentation/devicetree/bindings/pinctrl/pinctrl-mt6797.txt
create mode 100644 drivers/pinctrl/mediatek/pinctrl-mt6797.c
create mode 100644 drivers/pinctrl/mediatek/pinctrl-mtk-mt6797.h
create mode 100644 include/dt-bindings/pinctrl/mt6797-pinfunc.h


Linux-mediatek mailing list