C3000 General Info

From OESF

(Difference between revisions)
Jump to: navigation, search
Current revision (20:19, 20 January 2008) (edit) (undo)
 

(47 intermediate revisions not shown.)

Line 1:

Line 1:

-
Looks like nobody is here yet. I may be entering this in the wrong area. If so, forgive me and remove it! I think this is a WIKI, but I've never participated in one before.
+
Overview of specifications for the Sharp SL-C3000
-
My Zaurus SL-3000 should be in this week from Dynamism. One question I haven't been able to get a clear answer on yet is whether or not I can connect USB devices to the unit. I've been told it acts as a USB removeable drive with supplied cable. However, one review I saw said there is a mini USB port that is, in fact, a host USB port...but it takes a special "mini cable." Anybody have any info on that tiny cable?
+
* CPU
 +
** Intel XScale PXA270 416 MHz
 +
* ROM
 +
** 16MB Boot Flash in NAND
 +
** Unlike 860 it relies on the hard drive for mass non-volatile storage
 +
* RAM
 +
** 64 MB
 +
* Hard Disk
 +
** Internal CF-like socket fitted with 4 GB Hitachi microdrive
 +
* Card Slots
 +
** SD card slot (SDIO)
 +
** CF card slot
 +
* Communications
 +
** USB OTG 1.1 - slave and host (the latter needs USB Mini-A host cable)
 +
** IOPORT - the same connector as older models, but no USB, pins could provide less current, first series may have only JTAG there
 +
* Audio
 +
** Wolfson WM8750 codec (96 kHz, 24 bits)
 +
** 5 pin 3.5mm jack (4 pins + insert detection)
 +
** stereo out, semi-differential mono in
 +
** resistance meter (for remote control)
-
***
+
[[Category: Model Specs]]
-
The "mini USB" is only mini on the Zaurus side of the cable. It is a regular USB port cable on the side that plugs into your desktop.
+

Current revision

Overview of specifications for the Sharp SL-C3000

  • CPU
    • Intel XScale PXA270 416 MHz
  • ROM
    • 16MB Boot Flash in NAND
    • Unlike 860 it relies on the hard drive for mass non-volatile storage
  • RAM
    • 64 MB
  • Hard Disk
    • Internal CF-like socket fitted with 4 GB Hitachi microdrive
  • Card Slots
    • SD card slot (SDIO)
    • CF card slot
  • Communications
    • USB OTG 1.1 - slave and host (the latter needs USB Mini-A host cable)
    • IOPORT - the same connector as older models, but no USB, pins could provide less current, first series may have only JTAG there
  • Audio
    • Wolfson WM8750 codec (96 kHz, 24 bits)
    • 5 pin 3.5mm jack (4 pins + insert detection)
    • stereo out, semi-differential mono in
    • resistance meter (for remote control)
Personal tools