1
Sharp PC-Z1 NetWalker / Netwalker Apps Working List
« on: February 23, 2010, 11:50:02 am »
In addition here is a screenshot that shows all the applications on my netwalker desktop... [ Invalid Attachment ]
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Hi.Quote from: wowo123compiling on my Z terminated with lots of errors. Do you have a compiled version of passkey-agent?
Try this link:
http://www.zaurus.ru/board/download.php?id=20728
i use the following way to start it up in andromeda
/etc/init.d/dbus start
start-stop-daemon -S -b -x /bin/passkey-agent -- --default 1
hciconfig hci0 up piscan class 0x520104
rfcomm release rfcomm0
rfcomm bind rfcomm0
pon provider
Here 1 - my pin, passkey-agent you can find there http://www.zedd.nl/?p=8. This was the crucial moment to make it work.
It works fine for my nokia.
That was exactly what I was looking for. The rccomm.conf file wasn't correct. It can now establish a connection and begins the ppp connection. It gets to the point where it receives the auth method of CHAP MD5 And then receives the request for name = "" a response of name = "1234567890@1x.telusmobility.com" (replace 123....90 with my actual phone number) and then it receives CHAP authentication failed
It never gets to the point where it asks for the password.
I talked to telus support and they don't have the ability to view the logs to see if my username is being sent correctly. But I verified with them what it should be and its what PPP dialer says is being sent.
I read a few other posts about how the PPP Dialer double quotes the password but nothing about the username. The username is being sent in double quotes as shown above. But it looks like the request is asking for it to be in doublequotes.
In my /etc/ppp/peers/default (which is the one its using) it has what I can tell is correct:
/dev/rfcomm0
115200
connect 'usr/sbin/chat -s -v ABORT "NO CARRIER" ABORT "NODIALTONE" ABORT "BUSY" " "ATZ" OK ATDT#777 CONNECT'
crtscts
noipdefault
modem
user "1234567890@1x.telusmobility.com"
usepeerdns
defaultroute
connect-delay 60000
remotename default
i tried removing the "" around the user value as well.
I'm not sure if the remotename is correct.. but I don't even know what it should be. Telus support isn't very uesfull for validating or verifying anything as they seem to lack any ability to see what is happening. It would be very aparent im sure if they could just see what username was being submitted.
In my /etc/ppp/chap-secrets file it has:
1234567890@1x.telusmobility.com default "<password>"
I don't knwo if that default shoudl be there im sure its related to why its in the rfcomm.conf file.
Any suggestions would be apreciated.
you can download exiv2.ipk from here.Thanks for pointing me to this feed. Other needed files I found there too...