OESF Portables Forum

Everything Else => General Support and Discussion => Zaurus General Forums => Archived Forums => Security and Networking => Topic started by: Olivier on April 27, 2005, 03:41:38 pm

Title: Ettercap & C3000
Post by: Olivier on April 27, 2005, 03:41:38 pm

Hi,
I am running c3000 under original sharp rom
i have install ettercap_NG-0.7.0-rc1.ipk, and that was fine.
Unfortunately, when I launch ettercap from Qkonsole, or
from X server, I have got the error :
"The conversion from ISO-8859-1 to UTF-8 is not supported"
I have same error on 3 options:
 ettercap -T
 ettercap -C
 ettercap -G
I try to look for specific UTF & ISO package, but without result...


anyone got an idea...

Title: Ettercap & C3000
Post by: speculatrix on April 28, 2005, 08:29:22 am

Quote

Unfortunately, when I launch ettercap from Qkonsole, or
from X server, I have got the error :
"The conversion from ISO-8859-1 to UTF-8 is not supported"

tried setting the locale? (man locale)

Title: Ettercap & C3000
Post by: zmiq2 on May 02, 2005, 09:14:01 am

you can also try to comment out the line utf-8... in the etter.conf file

Title: Ettercap & C3000
Post by: Meanie on May 02, 2005, 12:05:39 pm

Quote

you can also try to comment out the line utf-8... in the etter.conf file
[div align=\"right\"][a href=\"index.php?act=findpost&pid=77864\"][{POST_SNAPBACK}][/a][/div]

you need to install glibc-gconv package then the error will be no more

Title: Ettercap & C3000
Post by: Olivier on May 08, 2005, 02:04:01 pm

OK, thanks for both replies.

I will try asap and give you the feed back.

OLivier

Title: Ettercap & C3000
Post by: Olivier on May 09, 2005, 04:24:34 am

I installed glibconv and can launch ettercap.

Nevertheless, when I run  "ettercap -Tzq" and try to get mail I have got error :
Error : 0, Success [ec_send.c:send_to_L3:162]
"libnet_build_data: libnet_build_data():payload iconsistency"

and ettercap NG-0.7.0_rcl exit.

I think it come from libnet version. (I have found only libnet 1.0.2 ipk).

If anybody know a link to a good ipk libnet version...
:-)

Title: Ettercap & C3000
Post by: Olivier on June 11, 2005, 02:43:02 pm

Finally i got etterca running under xqt xterm only.
Nevertheless Host scan dont detect any host on my lan.

when I start sniffing, and launch my browser I got 'L3 SEND ERROR'

If I write the log, all packet are in a pcap format.

IP forwarding seems not working. Does it come from libnet?

Does anyone succeed to solved these problem on zaurus?