OESF Portables Forum

Everything Else => Zaurus Distro Support and Discussion => Distros, Development, and Model Specific Forums => Archived Forums => Guylhem Rom => Topic started by: gfdsa on May 06, 2005, 02:08:24 pm

Title: Wlan
Post by: gfdsa on May 06, 2005, 02:08:24 pm

hm, how should internal prism be started ?

Title: Wlan
Post by: guylhem on May 06, 2005, 02:53:08 pm

use usbctl

Title: Wlan
Post by: jbruno on September 11, 2005, 03:52:43 pm

Quote

use usbctl
[div align=\"right\"][a href=\"index.php?act=findpost&pid=78582\"][{POST_SNAPBACK}][/a][/div]

I tried "usbctl on 1" and saw the light on my 6K turn on, but I can't figure out how to get it to connect to my LAN (which has WEP configured).  I tried to use the Settings/Internet utility to define a "Service" for my lan, but cannot figure ouit how to get it to start the service.

If I try "/etc/ini.d/wlan start", it says modprobe fail trying to find wlan0.

Is there a LAN setup howto for this ROM somewhere?

Title: Wlan
Post by: g3n on May 29, 2006, 11:25:03 am

Quote

Quote

use usbctl
[div align=\"right\"][a href=\"index.php?act=findpost&pid=78582\"][{POST_SNAPBACK}][/a][/div]

I tried "usbctl on 1" and saw the light on my 6K turn on, but I can't figure out how to get it to connect to my LAN (which has WEP configured).  I tried to use the Settings/Internet utility to define a "Service" for my lan, but cannot figure ouit how to get it to start the service.

If I try "/etc/ini.d/wlan start", it says modprobe fail trying to find wlan0.

Is there a LAN setup howto for this ROM somewhere?
[div align=\"right\"][a href=\"index.php?act=findpost&pid=95438\"][{POST_SNAPBACK}][/a][/div]

I have this same problem. i dont know where to start looking
/etc/rc.d/init.d/wlan start says /sbin/wlanctl-ng not found
i can see the light on when start the usbctl