OESF Portables Forum

Everything Else => Zaurus Distro Support and Discussion => Distros, Development, and Model Specific Forums => Archived Forums => Angstrom & OpenZaurus => Topic started by: Irongeek on January 22, 2004, 02:17:36 pm

Title: OpenZaurus 3.3.5 with Kismet and Wellenreiter II
Post by: Irongeek on January 22, 2004, 02:17:36 pm

I figured I’d leave this for anyone trying to get Wellenreiter II working on their 5500 with OpenZaurus 3.3.5. I had to replace the default Prism drivers with the ones from here:

http://opie.net.wox.org/wellenreiter/feed/....2-1_collie.ipk (http://opie.net.wox.org/wellenreiter/feed/openzaurus/armv4l-gcc2.95/hostap-modules_0.1.2-1_collie.ipk)

After that Kismet and Wellenreiter II worked fine.

Title: OpenZaurus 3.3.5 with Kismet and Wellenreiter II
Post by: Irongeek on January 24, 2004, 04:58:31 pm

Skip that Idea, I could not get it to work the 2nd time around. I Switched to 3.3.6-pre1-2.4.18-gcc3, Wellenreiter II just works out of the box then. By the way, with Open Zaurus 3.3.6-pre1-2.4.18-gcc3 you can use the Debian package of Ettercap 0.6.b-2 (found at http://packages.debian.org/unstable/net/ettercap) (http://packages.debian.org/unstable/net/ettercap)). Just rename ettercap_0.6.b-2_arm.deb to ettercap_0.6.b-2_arm.ipk and use the commandline:

ipkg -force-depends -d ram install ettercap_0.6.b-2_arm.deb

Don\'t know if it sees anything, but I\'ll find out more when I get my 10/100BT card.

Title: OpenZaurus 3.3.5 with Kismet and Wellenreiter II
Post by: nasteratu on January 31, 2004, 07:52:11 pm

Bleh if you know a way to get it working properly under 3.3.5 please post it, I would rather not use 3.3.6 just because it requires more time than I can put into it right now.