OESF Portables Forum
Everything Else => Zaurus - Everything Development => Distros, Development, and Model Specific Forums => Archived Forums => Qt/Qtopia => Topic started by: Ragnorok on May 12, 2005, 11:09:53 am
-
- I've finally gotten an usable (as in new enough hardware for noticable performance) Linux installation so I can set up for compilation for the C1000. I have an old (glacially slow) Linux setup for compiling for the SL-5500. If I use the same setup (install files, environment, configuration, etc) I used for the SL-5500, will it work on the C1000? It doesn't *seem* like it should.
- I searched this forum for "C1000" and found not a single post. So I searched the parent for "C1000" and found one post, but that guy appears to be doing local compilation (directly on the Z) instead of cross-compiling on Linux. It may be in another forum, but "Everything Development" sure seemed like the obvious place to look!! (cheshire grin)
- Any clues out there? Thanks for your time...
-
It's all still Qtopia 1.5.4, so your old environment should still work. I've use the old tools and instructions to compile for the 860...
-
- Wouldn't the virtual framebuffer geometry be wrong? Or is that configurable? Guess I should try it and see, huh? (drool) The other hardware is soooooo sllllooooowwww that I haven't touched it in months and months.
- Basically just trolling for caveats and whatnot. Thanks for your time...
-
- Wouldn't the virtual framebuffer geometry be wrong? Or is that configurable? Guess I should try it and see, huh? (drool) The other hardware is soooooo sllllooooowwww that I haven't touched it in months and months.
- Basically just trolling for caveats and whatnot. Thanks for your time...
[div align=\"right\"][{POST_SNAPBACK}][/a][/div] (http://index.php?act=findpost&pid=79632\")
[a href=\"http://www.qtopia.net/modules/developers/]Qtopia.net[/url]
-
- Thanks for the hand holding! Shouldn't have *needed* it, but thanks!