OESF Portables Forum

Everything Else => Zaurus Distro Support and Discussion => Distros, Development, and Model Specific Forums => Archived Forums => Sharp ROMs => Topic started by: PaulJolliffe on May 31, 2005, 05:42:09 pm

Title: Infrastructure Mode Not Working On 2511cf Mercury
Post by: PaulJolliffe on May 31, 2005, 05:42:09 pm

Hi,

I have been fighting with a the NL-2511CF card for sometime.  My zaurus is a C860 running the cacko 1.22 rom with the hotix installed.  The Zaurus can see the card and if I configure my laptop for adhoc mode I can get both the Zaurus and the laptop quite happily chatting away.  

The problem is when trying to get the card to work in Infrastrucure mode.  I have a Linksys Wap54G access point, with all security switched off (while configuring things) and the 2511 attempts to connect, but fails after a couple of minutes.  

During that time the Zaurus appears to hang and become unresponsive.  Eventually is comes up with a cant connect message.

Anyone got any ideas?  The problem only appears in Infrastructure mode?

Strange?

Cheers in advance

- Paul

Title: Infrastructure Mode Not Working On 2511cf Mercury
Post by: speculatrix on June 06, 2005, 04:21:06 pm

Quote

I have been fighting with a the NL-2511CF card for sometime.  My zaurus is a C860 running the cacko 1.22 rom with the hotix installed.  The Zaurus can see the card and if I

Hi,
I've not had any problems with my 2511 card, with infrastructure (with/without wep) and ad-hoc.

I simply used the cacko wizard.

Have you tried the iwconfig/ifconfig commands directly? Don't forget to "cardctl resume" before hand.

Paul