OESF Portables Forum

Everything Else => Sharp Zaurus => Model Specific Forums => Distros, Development, and Model Specific Forums => Archived Forums => C1000/3x00 Hardware => Topic started by: bar0n on June 23, 2005, 06:20:40 am

Title: C1000 Symbol/spectrum More Issues :-(
Post by: bar0n on June 23, 2005, 06:20:40 am

Hi all,
I've read a couple of posts regarding the Symbol Spectrum CF card on the C1000. I have successfully connected to my home and work APs without using WEP. However, when I enable WEP, I cannot connect.
I use "iwconfig eth0 key xxxxxxxx".
iwconfig shows the correct WEP key, but alas no luck. Anyone else had this?

Secondly, I'd like to use a wireless sniffer - Kismet, Wellenreiter or such.

I've set my capture source to wlanng,eth0,test and get ETH0: Device or Resource Busy. Setting to wlanng,wlan0,test gets: Interface wlan0: no such device.
I've tried setting up a dummy wireless connection as suggested elsewhere, but still no joy.

Wellwenreiter gives me SIOCSIFFLAGS: Device or resource busy. using eth0

I've tried entering my cardctl ident info into wlan-ng.conf.

Tearing my hair our now mad.gif

Does anyone else have this combination working with WEP and with a sniffer?

Thanks in advance!
Bar0n

Title: C1000 Symbol/spectrum More Issues :-(
Post by: wiredog on June 23, 2005, 11:02:39 am

Try turning off 'shared key' at the AP and the Z.

Title: C1000 Symbol/spectrum More Issues :-(
Post by: 4stupid on August 03, 2005, 05:00:38 am

Quote

Hi all,
I've read a couple of posts regarding the Symbol Spectrum CF card on the C1000. I have successfully connected to my home and work APs without using WEP. However, when I enable WEP, I cannot connect.
I use "iwconfig eth0 key xxxxxxxx".
iwconfig shows the correct WEP key, but alas no luck. Anyone else had this?

Secondly, I'd like to use a wireless sniffer - Kismet, Wellenreiter or such.

I've set my capture source to wlanng,eth0,test and get ETH0: Device or Resource Busy. Setting to wlanng,wlan0,test gets: Interface wlan0: no such device.
I've tried setting up a dummy wireless connection as suggested elsewhere, but still no joy.

Wellwenreiter gives me SIOCSIFFLAGS: Device or resource busy. using eth0

I've tried entering my cardctl ident info into wlan-ng.conf.

Tearing my hair our now mad.gif

Does anyone else have this combination working with WEP and with a sniffer?

Thanks in advance!
Bar0n
[div align=\"right\"][{POST_SNAPBACK}][/a][/div] (http://index.php?act=findpost&pid=85454\")

[a href=\"http://www.pumb.org/viewthread.php?fid=15&tid=657&pid=17847&page=4&extra=page%3D1#pid17847]http://www.pumb.org/viewthread.php?fid=15&...ge%3D1#pid17847[/url]