OESF Portables Forum

Everything Else => Sharp Zaurus => Model Specific Forums => Distros, Development, and Model Specific Forums => Archived Forums => C1000/3x00 General discussions => Topic started by: mschellens on June 24, 2005, 03:11:53 pm

Title: Internet Setting Wizard
Post by: mschellens on June 24, 2005, 03:11:53 pm

I switched my C3k to english.
Now I want to do TCP/IP over the usb port.
I believe this can be done with the Interne Setting Wizard
From NETWORK I choose Dialop/PPP then LAN Card
The next three screens are japanese only and I see only squares.
Could anybody tell what the mean?

Or is there another way to set this up?

Thanks,
ms

Title: Internet Setting Wizard
Post by: gtJormungand on June 28, 2005, 10:52:04 am

Actually, the Internet Settings window is not the correct place to do this.
Go to the "PC Link" settings and set the zaurus to use the "PC Link Setting".  Then set the hostname, wanted ip (usually 192.168.0.201), and then make sure the connection type is "USB - TCP/IP (advanced)".

Title: Internet Setting Wizard
Post by: mschellens on June 30, 2005, 01:06:16 pm

Quote

Actually, the Internet Settings window is not the correct place to do this.
Go to the "PC Link" settings and set the zaurus to use the "PC Link Setting".  Then set the hostname, wanted ip (usually 192.168.0.201), and then make sure the connection type is "USB - TCP/IP (advanced)".
[div align=\"right\"][a href=\"index.php?act=findpost&pid=86184\"][{POST_SNAPBACK}][/a][/div]

Thanks,
I did this, and samba works now fine.
But still the zaurus does not know what to route where and
any nameservers.
I think with the "PC Link Setting" you set up the hardware layer,
but with the Internet Settings the higher layers.
Of course it could be done from the command line, but the
Internet Setting should do it in a much more comfortable way.
ms