OESF Portables Forum
Everything Else => Zaurus Distro Support and Discussion => Distros, Development, and Model Specific Forums => Archived Forums => Sharp ROMs => Topic started by: thf on August 31, 2005, 06:37:26 am
-
Hi Forum,
I have "updateted" my C750 in cacko-rom 1.22 (a very good idea)!!!
There a a little problem by connect the zaurus to my network (192.1.202.0 ):
Connect to my pc with the usb-cable works fine (also samba, syncing,...)
But if I want to connect the zaurus by using the lan-card ( billionton) there is no samba availible. ssh is working fine. Internet by using the zaurus and a proxy works also fine.
in /etc/samba/smb.conf is also ok, i think
>>>>>
interfaces = usbd0 eth0 bnep0 irda0 irda1 #eth0 is the billionton
# wins support = yes
browseable = yes
# hosts allow = 192.168. # "#" at the front >> entry dont matter
<<<<<<
whats wrong??????
best regards
Thorsten
-
Hello again.
I have found the problem in the samba configuration:
In /etc/samba/smb.conf
"interface = usb0 eth0 bnep0 irda0 irda1"
So if I switch of this line
" # interface = usb0 eth0 bnep0 irda0 irda1"
and restart I can connect my zaurus also by samba.
But in this case the usb-connect and sync dosn't work.
Replace the line by " interface = #" also dosn't work
If I undestand the smb.conf in the right way, so the "interface" option allows onle the first entry to connect and ignore the other 4?!
any ideas??
Thorsten
p.s. The smb.conf is a link to readonly filesystem, so you have to rename the link and copy the file to /etc/samba/
-
Hello again.
I have found the problem in the samba configuration:
In /etc/samba/smb.conf
"interface = usb0 eth0 bnep0 irda0 irda1"
So if I switch of this line
" # interface = usb0 eth0 bnep0 irda0 irda1"
and restart I can connect my zaurus also by samba.
[div align=\"right\"][a href=\"index.php?act=findpost&pid=94288\"][{POST_SNAPBACK}][/a][/div]
I am seeing the same using Cacko 1.23. If I leave with the default interfaces config like the following:
interfaces = usbd0 eth0 eth1 wlan0 wlan1 bnep0 irda0 irda1
Then i can not connect from a Mac OS X 10.4.3 box. In fact, "findsmb" shows the following
charles% findsmb
*=DMB
+=LMB
IP ADDR NETBIOS NAME WORKGROUP/OS/VERSION
---------------------------------------------------------------------
192.168.1.7 ZAURUS +[ ZAURUS ]
If, however, I disable the "interfaces = " line with a #, then I can connect fine, and findsmb shows the following:
charles% findsmb
*=DMB
+=LMB
IP ADDR NETBIOS NAME WORKGROUP/OS/VERSION
---------------------------------------------------------------------
192.168.1.7 ZAURUS [ZAURUS] [Unix] [Samba 2.0.7-ja-2.2]
Interesting how it now dosplays more OS and Samba info.
If, however, I enable the interfaces line with anything beyond 1 interface, then I can not connect any more.
Is anyone else seeing this behavior? I would like to be able to SMB into my Zaurus using both wlan0 and usbd0, but can not see how that is possible currently.
C.