OESF Portables Forum

Everything Else => Zaurus Distro Support and Discussion => Distros, Development, and Model Specific Forums => Archived Forums => Angstrom & OpenZaurus => Topic started by: paimpol on October 14, 2005, 03:58:13 pm

Title: Error During The Installation
Post by: paimpol on October 14, 2005, 03:58:13 pm

Hello, for two weeks, i try to install openzaurus on my sl-c3000, but i can try all method i want, i have always the same problem.
When the Z reboot, i have a inode error with jffs2 ” Cannot remove child “zero”, ino #970, because it doesn’t exist”
and few lines before that, i have
“Ramdisk:couldn’t find valid ram disk image sarting at 0″
.
.
“cramfs:wrong magic”

In adition, could you tell me the difference between bootstrap-image and pivotboot-image in the download section for the sl-c3000 of the openzaurus web site

Title: Error During The Installation
Post by: paimpol on October 21, 2005, 01:22:55 am

my error was that i called the pivoboot initrd.img instead of initrd.bin.
It's all!

stupid, isn't it?

Title: Error During The Installation
Post by: tom_sawyer on December 13, 2005, 04:57:52 pm

Quote

my error was that i called the pivoboot initrd.img instead of initrd.bin.
It's all!

stupid, isn't it?
[div align=\"right\"][a href=\"index.php?act=findpost&pid=100287\"][{POST_SNAPBACK}][/a][/div]

hello,

I have same message of you but with correct name of bin: initrd.

i have message each time i reboot my C1000.

i'm searching for explanation in old post in this forum.

tom.

Title: Error During The Installation
Post by: paimpol on December 15, 2005, 11:26:50 am

have you cleaned your partitions before installing the OZ.
If you have save all your data, you can follow the instruction at
http://www.xlfag.com/zaurus/ (http://www.xlfag.com/zaurus/)

just follow the step 4 for have good partition.