OESF Portables Forum

Everything Else => Desktop Operating Systems Issues => Zaurus General Forums => Archived Forums => Windows Issues => Topic started by: .mau. on October 24, 2005, 11:42:32 am

Title: Synchronization (as Usual :-( )
Post by: .mau. on October 24, 2005, 11:42:32 am

I am trying to set up the USB TCP/IP communication between my C860 (Cacko 1.21) and a PC with XP installed. I installed the NDIS v3 drivers on the PC, and the two machines see one another; on the Z PC link says "USB IP 192.168.129.201, connection USB -TCP/IP", and I can ping 192.168.129.201 from the PC and 192.168.129.1 from the Zaurus.

However, if I launch Intellisync it asks to connect the Zaurus, but it cannot start the connection, and it asks to change the IP on the Z to 192.168.130.201. If I try to do it (of course after disconnecting) it wants 192.168.131.201, and so on.

I vaguely remember that there was a trivial thing to do, but I cannot rememeber which it is. Any suggestion?

ciao, .mau.

ps: the PC has no firewall on at the moment, of course.

Title: Synchronization (as Usual :-( )
Post by: .mau. on October 31, 2005, 04:53:38 am

I forgot: of course I may connect to the Z from the PC with ssh or sftp.

Title: Synchronization (as Usual :-( )
Post by: SharpEnd on November 05, 2005, 12:41:11 am

Do you have Windows Firewall turned on?
I found that I couldn't connect with it on, but turn it off and could then sync, file transfer, etc.

Title: Synchronization (as Usual :-( )
Post by: .mau. on November 10, 2005, 10:10:11 am

Quote

Do you have Windows Firewall turned on?

no, I checked it was off.