OESF Portables Forum

Everything Else => Sharp Zaurus => Model Specific Forums => Distros, Development, and Model Specific Forums => Archived Forums => 6000 - Tosa => Topic started by: Mjolinor on November 06, 2005, 05:06:49 am

Title: Expansion Connector
Post by: Mjolinor on November 06, 2005, 05:06:49 am

Anyone have the pinouts for the expansion connector on the bottom of the 6000. I figure there is room in the little plastic cover for at least a USB miniB and probably a serial as well.

Would also need a connector to fit. After much rummaging through dead bits I have nothing remotely like it. It probably doesn't need to be a full connector just one with similar pin spacing as it's location would be fixed by the plastic cover.

Title: Expansion Connector
Post by: adf on November 06, 2005, 05:08:45 am

I've wondered this too.... though I was thinking maybe a cf connector in there?

Title: Expansion Connector
Post by: guylhem on November 06, 2005, 03:38:13 pm

Well if anyone has the maintainance manual for the 6000, it should be there. I'd gladly take a copy of this manual BTW.

Title: Expansion Connector
Post by: adf on November 07, 2005, 10:17:06 am

LOL..that is the issue, isn't it?

or dissecting an expensive and rare sled

Title: Expansion Connector
Post by: Mjolinor on November 07, 2005, 11:18:58 am

Maybe a start would be

What does the expansion jacket give you and has it "active" electronics in or is it maiinly a passive device.

or

Anyone got a dead 6000