OESF Portables Forum

Everything Else => Desktop Operating Systems Issues => Zaurus General Forums => Archived Forums => Linux Issues => Topic started by: Wawrzek on November 10, 2005, 05:40:48 am

Title: Zync And Crux
Post by: Wawrzek on November 10, 2005, 05:40:48 am

Hello,

I tried to build zync on Crux (http://crux.nu), but i failed.
First there are no,

Code: [Select]

/usr/lib/qt3/mkspecs/default/qmake.confbut i found

Code: [Select]

/usr/share/qt/mkspecs/linux-g++/qmake.conf and changed the Makefile.
Then there is no libqt.prl in whole system nor in any of ports.

What should I do? Maybe this file can have other name?

Title: Zync And Crux
Post by: cyphactor on December 08, 2005, 05:50:46 pm

Quote

Hello,

I tried to build zync on Crux (http://crux.nu), but i failed.
First there are no,

Code: [Select]

/usr/lib/qt3/mkspecs/default/qmake.confbut i found

Code: [Select]

/usr/share/qt/mkspecs/linux-g++/qmake.conf and changed the Makefile.
Then there is no libqt.prl in whole system nor in any of ports.

What should I do? Maybe this file can have other name?
[div align=\"right\"][a href=\"index.php?act=findpost&pid=103093\"][{POST_SNAPBACK}][/a][/div]

Hmm, I am not aware of it having any other name. My suggestion would be to not worry about zync-gui from this point on and just use zync. The reason I say this is because there have been lots of problems with the Qt based Zync-gui and it is going to be re-written using FLTK rather than qt so there will be less problems.