OESF Portables Forum

Everything Else => General Support and Discussion => Zaurus General Forums => Archived Forums => Software => Topic started by: bam on November 20, 2005, 12:33:41 am

Title: Prboom Problem
Post by: bam on November 20, 2005, 12:33:41 am

getting a undefined symbol problem __divid3? Any ideas? I have a Doom1.wad file and it sees it but during load it dies. BTW installed as per Meanies instructions and provided prboom.cfg file

Title: Prboom Problem
Post by: bam on November 20, 2005, 11:54:12 pm

ok now getting W_GetNumForName: CRBRICK not found

any further ideas?

Title: Prboom Problem
Post by: Antikx on December 12, 2005, 08:29:54 pm

Quote

ok now getting W_GetNumForName: CRBRICK not found

any further ideas?
[div align=\"right\"][a href=\"index.php?act=findpost&pid=104374\"][{POST_SNAPBACK}][/a][/div]

I just installed from the Cacko Lite feed and it works without errors. Although I think I had to change the config file some where in ~ to point to the proper place that prboom was installed. I had to fix the UDLR keys too.

Title: Prboom Problem
Post by: Antikx on December 12, 2005, 10:40:50 pm

Quote

ok now getting W_GetNumForName: CRBRICK not found

any further ideas?
[div align=\"right\"][a href=\"index.php?act=findpost&pid=104374\"][{POST_SNAPBACK}][/a][/div]

I was trying to get the doom2 wad working and I was able to duplicate your problem. Once I put the orig wad files (doom.wad and prboom.wad, I think) back where they were orig put, it ran fine with the doom2 wad.

Title: Prboom Problem
Post by: craigtyson on December 13, 2005, 08:22:18 am

try checking your paths in the doom.cfg  and also in the doom launcher Bash scripts ie doom and doom-demo

I found both were pointing to the wrong directory after installing from the Cacko feed.