OESF Portables Forum
Model Specific Forums => Sharp Zaurus => Zaurus - pdaXrom => Topic started by: asys3 on November 27, 2005, 11:41:23 am
-
Hi,
I both tried wpa_supplicant 0.38 and 0.39 from unstable - with
no success
I always got
linkstatus=6 (association failed)
Has anybody a solution for that?
I tried wpa-psk as described in the wpa...conf.example....
Regards
Uwe
-
I think you need the Hostap drivers :-)
-
I think you need the Hostap drivers :-)
[div align=\"right\"][a href=\"index.php?act=findpost&pid=105135\"][{POST_SNAPBACK}][/a][/div]
It doesn't matter - both orinoco and hostap drivers fail.
I just upgraded my Linksys WCF12 to the latest PRISM firmware 1.1.0/1.8.4 - same
result :-(
Connecting with no encryption works well.
Is there anyone who has a Linksys WCF12 and could connect with WPA to his access point?
Thanks for every help.
I'm a little bit frustrated...
Regards,
Uwe
-
It seems that even with the latest firmware update my prism III based Linksys WCF12 doesn't
support WPA.
So I looked for a WLAN CF Card with WPA support and couldn't find one.
Perhaps they don't exist...
Regards,
Uwe
-
I got it working now - but only with Cacko 1.23.
I followed the instructions at
OESF-Cacko Board (https://www.oesf.org/forums/index.php?showtopic=10699)
and got WPA-PSK working with RC12.
Before that I flashed my firmware of the WCF12 (now: station V1.1.1 / primary V1.8.4) - you can find
the flash instructions in the thread above, too.
Type "hostap_diag wifi0" to look at the firmware versions.
And, yes - I use hostap in Cacko.
It connects fine with my WRT54GS.
Perhaps anyone gets it working in pdaxrom - I'll try it again with RC>RC12 - because
the ROM it's worth...
Thanks for all the hints (and the audience )
Uwe