OESF Portables Forum
Everything Else => Model Specific Forums => Distros, Development, and Model Specific Forums => Archived Forums => SIMpad forum => Topic started by: mr_nice on December 05, 2005, 05:54:23 pm
-
Hello,
I want to add a switch wich switches between the irda and a new serial port on the irda.
Is it possible to use the irda as rs323?
I dont meen these adapters. I want to solder some cable on the irda and add an switch so I could use my mouse or sth. on that port and if I ever need the irda so is switch between them.
Any pinouts?
thx
mr_nice
[EDIT]
I've just found those pinouts[1] on my favorite pinoutsite[2].
There is no standard pinout, but some examples are listed.
5 pin IDC male connector layout
5 pin IDC male connector at the motherboard
Pin Name Direction Description
1 Vcc +5V Vcc +5V DC
2 NC -?- Not connected
3 IRRX RX Data
4 GND Ground
5 IRTX TX Data
for FIC FA-11 motherboard (and others)
Pin Name Direction Description
1 Vcc +5V Vcc +5V DC
2 IRRX RX Data
3 GND Ground
4 IRTX TX Data
5 CIRRX Consumer IR Receiving
1 http://pinouts.ru/data/IrDa_ABIT_pinout.shtml (http://pinouts.ru/data/IrDa_ABIT_pinout.shtml)
2 http://pinouts.ru (http://pinouts.ru)