OESF Portables Forum

Everything Else => Zaurus Distro Support and Discussion => Distros, Development, and Model Specific Forums => Archived Forums => Angstrom & OpenZaurus => Topic started by: merciless on February 11, 2004, 08:11:56 pm

Title: VNC with OZ3.2
Post by: merciless on February 11, 2004, 08:11:56 pm

I installed fbvncserver_0.9-4_arm.ipk on OZ3.2. After installation, I rebooted and performed the calibration step. When I run the viewer on the PC, it connects to the Zaurus without any problem. I am able to do everything on the Zaurus screen using the mouse. However, I am unable to utilize the PC keyboard. I am also unable to use the buttons on the keypad when I click on them using the mouse.

Anybody else has this problem or can provide some help? Thanks.

Title: VNC with OZ3.2
Post by: Anonymous on February 17, 2004, 07:34:51 am

Hello,

I use too VNC and I have the same problem : the keyboard does not work.
Unfortunatly, it seems a well-known problem and (tell me if I made a mistke) there is no solution for the moment.

CU

Title: VNC with OZ3.2
Post by: Anonymous on February 17, 2004, 10:50:16 am

Hello,


Try this vncserver.  I installed it and I have no problem with the pc keyboard.  The installation is the same as the other vncserver.
Hope this helps. http://www.madb.de/zaurus/opie-030814-1819...r_0.9-4_arm.ipk (http://www.madb.de/zaurus/opie-030814-1819/fbvncserver_0.9-4_arm.ipk)

JP

Title: VNC with OZ3.2
Post by: Joshp on February 17, 2004, 10:51:08 am

Sorry that was me above.  Forgat that wasn\'t loged in.