OESF Portables Forum

Everything Else => Sharp Zaurus => Model Specific Forums => Distros, Development, and Model Specific Forums => Archived Forums => C1000/3x00 General discussions => Topic started by: xamindar on February 14, 2006, 05:59:48 am

Title: Program Icons Too Small
Post by: xamindar on February 14, 2006, 05:59:48 am

Today, all of a sudden all my icons became very small and the X/qt cramfs stuff doesn't start when I tap on the icons.  They will still start if I run them from a console though, very strange.

Last thing I remimber is suspending my Z while X/qt was running and the next time I unsusspended it X must had crashed because it was gone.  I have rebooted a couple of times but no change.  Has anyone else experienced this?  How do I get my icons back to normal and X/qt running correctly again?

I attached a picture so you can see what it looks like currently.

Title: Program Icons Too Small
Post by: tombraider on February 14, 2006, 07:15:09 am

Did you try the "zoom in"/ "zoom out" on the "start" button??

Quote

Today, all of a sudden all my icons became very small and the X/qt cramfs stuff doesn't start when I tap on the icons.  They will still start if I run them from a console though, very strange.

Last thing I remimber is suspending my Z while X/qt was running and the next time I unsusspended it X must had crashed because it was gone.  I have rebooted a couple of times but no change.  Has anyone else experienced this?  How do I get my icons back to normal and X/qt running correctly again?

I attached a picture so you can see what it looks like currently.
[div align=\"right\"][a href=\"index.php?act=findpost&pid=114755\"][{POST_SNAPBACK}][/a][/div]

Title: Program Icons Too Small
Post by: xamindar on February 14, 2006, 12:38:28 pm

OH MY GOSH!!!

Thank you.

I feel so stupid.  By the way, after I rebooted Xqt worked again.

Title: Program Icons Too Small
Post by: bluedevils on February 14, 2006, 01:26:45 pm

You probably hit fn+1