OESF Portables Forum

Everything Else => Zaurus Distro Support and Discussion => Distros, Development, and Model Specific Forums => Archived Forums => Sharp ROMs => Topic started by: Petra on March 07, 2006, 07:14:38 am

Title: "file Read Error" Restore Sharp Rom C1000
Post by: Petra on March 07, 2006, 07:14:38 am

Hi,

I'm a newbie, so perhaps I have a little bit a stupid question  
I hope you can help me.

I have put the Cacko 1.23 rom on my C1000 via a SD card. Later I wanted to restore the original Sharp ROM. At the end of the restore, the green line was almost to the right, there came an error on the screen: Restore ... failed file read error.
Then I've tried the Nand from Trisoft and it failed too.

Can anyone help me with this?
Thanks.

Title: "file Read Error" Restore Sharp Rom C1000
Post by: TRIsoft on March 07, 2006, 08:16:21 am

Petra,
maybe you picked a bad card. The service menu is a bit more
fussy about the cards compared to the normal usage. So even
cards that work fine with QTopia may not work for NAND
operations.

Try another one (preferably a CF card) and cross fingers.
If it's not the card, then it looks very much like a faulty NAND
chip. In this case, you should contact your dealer for a
warranty replacement / repair.

///TRIsoft

Marc Stephan

Title: "file Read Error" Restore Sharp Rom C1000
Post by: Petra on March 07, 2006, 09:59:02 am

Thanks Marc.

I've restored an original Japanese ROM. The Zaurus gave me a "file read error" again but after reboot it worked. Later I've installed a little program to convert Japanese to English (from Conics.net).