OESF Portables Forum
Everything Else => Zaurus Distro Support and Discussion => Distros, Development, and Model Specific Forums => Archived Forums => Sharp ROMs => Topic started by: urania on March 11, 2006, 01:25:38 am
-
Hello,
I am using a planex GW-CF11X with a linksys WAP54G for my AP.
The wifi is working well, execpt that i have to use my AP as "Wireless b only"
The connection is not working if i used "mixed mode" -> b and g
Any idea ?
Thx
-
Hello,
I am using a planex GW-CF11X with a linksys WAP54G for my AP.
The wifi is working well, execpt that i have to use my AP as "Wireless b only"
The connection is not working if i used "mixed mode" -> b and g
Any idea ?
Thx
[div align=\"right\"][a href=\"index.php?act=findpost&pid=118001\"][{POST_SNAPBACK}][/a][/div]
no one ?
-
I just received a wifi cf card and am currently running cacko 1.23 on akita.
The card is unknown! So I got a worse problem. Its a XI-825 model, and is using prism 2.5 chipset.
It works out of the box in oz/gpe on my collie ... though I still could not ping the notebook it connected with.
-
I have the same card with a MAXg adsl router from USR model 9108 and it works very good... I use it ine G+ performance with no problems I have also use B cisco pcmcia cards with linux or openbsd with it..
I think its a config problem by you.
ps. I have no wep or other security.
-
I just received a wifi cf card and am currently running cacko 1.23 on akita.
The card is unknown! So I got a worse problem. Its a XI-825 model, and is using prism 2.5 chipset.
It works out of the box in oz/gpe on my collie ... though I still could not ping the notebook it connected with.
[div align=\"right\"][a href=\"index.php?act=findpost&pid=129872\"][{POST_SNAPBACK}][/a][/div]
Probably only a new entry in /etc/pcmcia/hostap_cs.conf is needed for that card.
With "cardctl ident" after inserting the card you can determine the needed settings for "manfid" or "version" in the conf file entry.
daniel