OESF Portables Forum

General Forums => General Discussion => Topic started by: Mjolinor on March 12, 2006, 05:08:57 am

Title: Remote Control
Post by: Mjolinor on March 12, 2006, 05:08:57 am

I just sold my 860 and forgot that I had a CE-RH1 remote so I now need to alter it to make it work on my 3000 ie change it into a CE-RH2.

Assuming it works in the same way the I just need the impedance values for the 5 functions.

The RH1 control is from the two connections on the plug nearest to the wire, not the tip.

The RH1 is a follows.

No button: OC
Volume up: 2500 ohms
Volume down: 6400 ohms
Fast forward: 1300 ohms
Fast rewind: 700 ohms
Stop: 360 ohms

Will some kind person please measure those on an RH2.

Title: Remote Control
Post by: Da_Blitz on March 12, 2006, 07:19:56 pm

resistance values for RH2. 330, 470, 680, 910,1.5k,3.3k,18k

see https://www.oesf.org/forums/index.php?showt...15333&hl=ce-rh2 (https://www.oesf.org/forums/index.php?showtopic=15333&hl=ce-rh2) for schematic, just change the vals to the ones noted above (notice the asscending order on both

Title: Remote Control
Post by: dbowden on March 13, 2006, 09:20:14 am

Quote

resistance values for RH2. 330, 470, 680, 910,1.5k,3.3k,18k

see https://www.oesf.org/forums/index.php?showt...15333&hl=ce-rh2 (https://www.oesf.org/forums/index.php?showtopic=15333&hl=ce-rh2) for schematic, just change the vals to the ones noted above (notice the asscending order on both
[div align=\"right\"][{POST_SNAPBACK}][/a][/div] (http://index.php?act=findpost&pid=118240\")

Don't forget to swap the Key and GND wires to the connector.  They got swapped between the CE-RH1 and CE-RH2.  See [a href=\"https://www.oesf.org/forums/index.php?showtopic=15333&hl=creative%20zen&st=15#]this discussion.[/url]

Title: Remote Control
Post by: Mjolinor on March 13, 2006, 09:58:56 am

OK thanks for the input. I did try searching.

Title: Remote Control
Post by: Da_Blitz on March 14, 2006, 05:25:35 am

searching for more than one word dosent work like it does on google so watch out, it seems to look for the entire phrase

Title: Remote Control
Post by: Mjolinor on March 14, 2006, 06:56:37 am

Quote

searching for more than one word dosent work like it does on google so watch out, it seems to look for the entire phrase
[div align=\"right\"][a href=\"index.php?act=findpost&pid=118481\"][{POST_SNAPBACK}][/a][/div]

You can use boolean operators

 searching for "searching AND word" will bring back your post.