OESF Portables Forum

Everything Else => General Support and Discussion => Zaurus General Forums => Archived Forums => Software => Topic started by: daniel3000 on April 03, 2006, 08:58:47 am

Title: Image Viewer For Qtopia
Post by: daniel3000 on April 03, 2006, 08:58:47 am

Hello,

for embedding into the mutt email client, I'm looking for an image viewer (jpg, gif, maybe: png, tif, fax, bmp and other popular formats) which works under QTopia but is callable from the command line.

The built-in "Imaging" applicatoin would be good enough I guess, but I coudn't figure out how to call it from the command line.

Thanks
daniel

Title: Image Viewer For Qtopia
Post by: nilch on April 03, 2006, 02:03:29 pm

The built in image viewer - Imaging - is callable from command line - "zimager".

Also the photostarage application (also by Sharp) is callable too - "photostorage"
(the phtostorage as a viewer is better than Imaging.

Imaging does take command line parameters as well - pass the pull path of file to view. Now, I don't know if photostorage takes any commandline parameters as well or not.

Title: Image Viewer For Qtopia
Post by: daniel3000 on April 04, 2006, 05:42:03 am

Quote

The built in image viewer - Imaging - is callable from command line - "zimager".

Also the photostarage application (also by Sharp) is callable too - "photostorage"
(the phtostorage as a viewer is better than Imaging.

Imaging does take command line parameters as well - pass the pull path of file to view. Now, I don't know if photostorage takes any commandline parameters as well or not.
[div align=\"right\"][a href=\"index.php?act=findpost&pid=121636\"][{POST_SNAPBACK}][/a][/div]

Thanks!

photostorage does not react to any command line parameter.
So I tried zimager and it works nicely.
However, I was not able to figure out how to tell zimager to go immediately into fullscreen mode, which would be nice.

daniel