OESF Portables Forum
Everything Else => Zaurus Distro Support and Discussion => Distros, Development, and Model Specific Forums => Archived Forums => Angstrom & OpenZaurus => Topic started by: ant on April 27, 2006, 01:19:14 pm
-
I was reading the gpe-roadmap and it appears very promising:
http://www.handhelds.org/moin/moin.cgi/GPERoadmap (http://www.handhelds.org/moin/moin.cgi/GPERoadmap)
http://www.handhelds.org/moin/moin.cgi/GPEToFixFor2_2e8 (http://www.handhelds.org/moin/moin.cgi/GPEToFixFor2_2e8)
I'm waiting for a ppp-dialer and a unified if up/down applet.
Are perhaps some new bits already in beta?
-
I'm waiting for a ppp-dialer
[div align=\"right\"][{POST_SNAPBACK}][/a][/div] (http://index.php?act=findpost&pid=124814\")
'ipkg install gkdial' or 'ipkg install gkdial-gnomeless'
and have a look at [a href=\"http://helmsdeep.homelinux.net/~pat/wordpress/]http://helmsdeep.homelinux.net/~pat/wordpress/[/url]
-
Good to know!
I have only found "gkdial", installs ok (with a couple of dependencies) but then complains "Your kernel is missing PPP support" and doesn't connect...
BTW I edited the peer and set /dev/rfcomm0 instead of /dev/modem
???
EDIT:
The kernel modules are installed, but there is a new udev quirk:
pppd is unable to open the /dev/ppp device. You need to create the /dev/ppp/device/node by executing the following command as root: mknod /dev/ppp c 108 0
-
<BUMP>
Any news about GPE 2.8 ?
-
Any news from the developers?
-
Any news from the developers?
[div align=\"right\"][a href=\"index.php?act=findpost&pid=132593\"][{POST_SNAPBACK}][/a][/div]
try mailing gpe@handhelds.org, since no gpe developer reads this forum