OESF Portables Forum

Everything Else => Zaurus Distro Support and Discussion => Distros, Development, and Model Specific Forums => Archived Forums => Sharp ROMs => Topic started by: andresgriego on May 05, 2006, 01:05:23 pm

Title: How Do I Get A Wcf12 To Work Under Cacko?
Post by: andresgriego on May 05, 2006, 01:05:23 pm

I am having troubles getting a Linksys WCF12 wirking under Cacko. I'm hoping someone can shed some light on my predicament.

EDIT:
Nevermind, I'm NOT going to flash the firmware today.

Is there anything else I can try?

From a previous post, here's what Ive done so far:

Quote

I created a new 'Wireless' profile in the Network applet in the Settings.

I have turned off AutoConnect in the Network applet in two places, the checkbox on the bottom labelled 'Autoconnect' and in the profile Wireless where it says 'Auto'.

I have set essid to 'sol' which is the same as the SSID value in my router.

NOTE: The connect button at the bottom of the Network applet is greyed out.

wlan-ng.conf
Removed all references to cards except mine.
Left in the top 2 lines:
1. device "prism2_cs"
2. class"wlan-ng" ...

Hostap_cs.config
Removed all references to cards except mine.
Left in the top 2 lines:
1. device "hostap_cs"
2. class"hostap" ...
I also left in the three lines of comments at the bottom.

The MANFID in both these files matches the output of the command: 'cardctl info'

I have reboot Cacko after making these changes. I have also tried 'remove the card(via taskbar ejector), /etc/.../pcmcia restart, insert the card'.
[div align=\"right\"][a href=\"index.php?act=findpost&pid=125465\"][{POST_SNAPBACK}][/a][/div]

Thanks,

Andres

Title: How Do I Get A Wcf12 To Work Under Cacko?
Post by: Hrw on May 05, 2006, 01:48:05 pm

leave only hostap config (if you have hostap drivers installed)