OESF Portables Forum
Everything Else => Sharp Zaurus => Model Specific Forums => Distros, Development, and Model Specific Forums => Archived Forums => C1000/3x00 General discussions => Topic started by: ian.finder on May 23, 2006, 01:30:16 am
-
So, I was playing around in the D+M menu on my "new" used "less than 10 hours" sl-c1000 from ebay (yes, I have my doubts-- for other reasons as well)
and I ran the NAND Bad Count from the sum menu. I got the result you see attached (that line of interest is "8 4 0 4" if you can't see-- block 8, 4 init, 0 after, 4 total bad blocks)
Anyhow, the ominous large, red ascii "NG!" is concerning me-- should it be?
Thanks in advance--
[ EDIT - I just realized I should have put this in the hardware section. Sorry! ]
Ian
P.S.: As a new member, and someone who's beginning to love these Sharps (replaced my debian-powered libretto 50ct), I hope to more active on these forums in the future, and once I get familiar with the platform, I hope to contribute to development. (Installing the cross-compilers now on my desktop). Either way, I was very happy to find this site, as it seems to be an invaluable resource!
-
Anyhow, the ominous large, red ascii "NG!" is concerning me-- should it be?
[div align=\"right\"][a href=\"index.php?act=findpost&pid=128133\"][{POST_SNAPBACK}][/a][/div]
Subject to correction by the real experts on the forum, I have had that error routinely, the number of blocks (4 in my case) has remained the same rather than increasing, and it hasn't caused a problem. I think that it means that some small number of blocks in memory are bad and have been flagged and are not used. The only consequence I've seen is that I have sometimes found it necessary to specify a couple of MB more memory for the root partition than usually recommended when flashing a new ROM or I will get boot errors.
-
Anyhow, the ominous large, red ascii "NG!" is concerning me-- should it be?
[div align=\"right\"][a href=\"index.php?act=findpost&pid=128133\"][{POST_SNAPBACK}][/a][/div]
Subject to correction by the real experts on the forum, I have had that error routinely, the number of blocks (4 in my case) has remained the same rather than increasing, and it hasn't caused a problem. I think that it means that some small number of blocks in memory are bad and have been flagged and are not used. The only consequence I've seen is that I have sometimes found it necessary to specify a couple of MB more memory for the root partition than usually recommended when flashing a new ROM or I will get boot errors.
[div align=\"right\"][a href=\"index.php?act=findpost&pid=128164\"][{POST_SNAPBACK}][/a][/div]
Thanks for the response-- I haven't had issues yet, and hopefully I won't. *Fingers Crossed*
on the other hand, my new 3200 shows no bad blocks. Hopefully it will stay that way, and the 4 on the 1000 stay within normal tolerance.
In the meantime, on a related note, I'm perfecting a little script for a few roms (cacko, pdaxrom-- one version of each tested so far) that moves and links frequently accessed files (logs, etc.) to another storage medium (harddrive, sd, etc) to prevent internal flash wear. I might add a ramdisk portion that's saved at shutdown too. If people show interest, when it's done and tested, I'll release it. It's nothing most of us couldn't do on our own, but hopefully this will make things "quick and painless."