OESF Portables Forum
Everything Else => Sharp Zaurus => Model Specific Forums => Distros, Development, and Model Specific Forums => Archived Forums => 5x00 General discussions => Topic started by: pcombe01_SL5500 on June 30, 2006, 09:29:19 pm
-
I have installed Open Zaurus to an SL 5500. Now I show the following.
Total Memory 62412 kB
Used 10124 kB
Buffers kB
Cached 12256 kB
Free 40004 kB
Internal Storage /dev/root
Used 14352 kB Available 112 kB
SD Card
Used 12368 kB Available 226822
Inspite of showing free memory when I try to save data to the device it says no memory left. I have tried creating a local user account but it will not write to /home.
Hope this is not to basic a question. Thanks in advance for any suggestions.
PMC
-
Hi,
If understand your issue correctly, you are trying save to a place that has no
space (not memory as in RAM) left. You have plenty of memory left, but that
is not where /home is located. I believe this occurs when using (installing)
the 64-0 configuration. It's been a while since I used OZ, but if you "move"
/home to the SD card, you will then be able to save as much as the SD card
has free. I suspect that you will find instructions or posts that will cover that,
most likely in one of the three OZ forums.
John
-
Hi John
Thank you for the advice. I think your solution is the correct and I will check the suggested OZ forums.
Regards,
PMC
Hi,
If understand your issue correctly, you are trying save to a place that has no
space (not memory as in RAM) left. You have plenty of memory left, but that
is not where /home is located. I believe this occurs when using (installing)
the 64-0 configuration. It's been a while since I used OZ, but if you "move"
/home to the SD card, you will then be able to save as much as the SD card
has free. I suspect that you will find instructions or posts that will cover that,
most likely in one of the three OZ forums.
John
[div align=\"right\"][a href=\"index.php?act=findpost&pid=133581\"][{POST_SNAPBACK}][/a][/div]