OESF Portables Forum
Model Specific Forums => Sharp Zaurus => Zaurus - pdaXrom => Topic started by: Andmann on July 03, 2006, 12:09:52 am
-
Hi all,
I just installed Beta 4, which went perfectly well, no issues.
I have an Ambicom 802.11b card which is recognized by the system and comes up as:
WL1100C 302.11B CF-Card 2.2
The card light flashed on and off as if it is searching, just like it did with other roms.
It doesn't link to any network. I have tried 3 different networks and nothing.
2 of them are open networks and one is wep.
I ran dmesg and I get the following when I insert the card.
PCMCIA card inserted into slot 0
registering new device pcmcia0.0
hostap_cs: setting Vcc=33 (constant)
hostap_cs: setting Vcc=33 (from config)
checking CFTABLE_ENTRY 0x01 (default 0x01)
IO window settings: cfg->io.nwin=1 dflt.io.nwin=1
io->flags = 0x0046, io.base=0x0000. len=64
hostap_cs: Registered netdivice wifi0
hostap_cs: index 0x01: Vcc 3.3 irg 137, io -xc4820000-0xc482003f
prism2_hw_init: initialized in 200ms
wifi0: NIC: id=0x800c v1.0.0
wifi0: PRI: id=0x15 v1.0.7
wifi0: STA:id=0x1f v1.3.6
wifi0: defaulting to host-based encryption as workaround for firmware bug in host AP mode WEP
wifi0: defaulting to bogus WDS frame as a workaround for firmware bug in Host mode WDS
wifi0: registered netdevice wlan0
-- ffeewww--- now that was some typing..
when I run ifconfig it only brings up lo, there is not other listings
I also have a symbol card but that doesn't even light up with beta4 so that is why I am trying to get this one working.
Once I get this working I want to get it attached to my WAP network but that is for another day.
Thanks in adavanced.
-
Symbol Spectrum24 CF card will work in beta4... it just required the firmware to be placed in the correct place...
Look Here (https://www.oesf.org/forums/index.php?showtopic=19301&st=135&p=127294&#entry127294)
This post shows you where to place the firmware and supplies the firmware also...
Late
-
Symbol Spectrum24 CF card will work in beta4... it just required the firmware to be placed in the correct place...
Look Here (https://www.oesf.org/forums/index.php?showtopic=19301&st=135&p=127294&#entry127294)
This post shows you where to place the firmware and supplies the firmware also...
Late
[div align=\"right\"][a href=\"index.php?act=findpost&pid=133740\"][{POST_SNAPBACK}][/a][/div]
Thanks, I now get the flashing light on the symbol card too, but still no connectivity.
It is now working the same as my ambicom card..
Just a flashing light.
dmesg has several entrys with eth0 which all look good.
second last one says "ready"
Firmware on the card comes up as 3.91-71
Not sure if this helps.
thanks in adavance again.
Andmann