OESF Portables Forum
Everything Else => Sharp Zaurus => Model Specific Forums => Distros, Development, and Model Specific Forums => Archived Forums => C1000/3x00 General discussions => Topic started by: dimsons on August 01, 2006, 01:41:31 am
-
hi everybody!
Need your professional help. How to connect Z through USB with mobile? Should i install some drivers on Z? The case is that on my notebook i installed USB driver for mobile`s modem before it started working
Will wait your answer
-
should appear as a usb modem for those of you running a 2.6 kernel with udev
otherwise you will need to dial over the device /dev/ttyUSB0. how you do that and establish a ppp connection is left to the reader you may need to load a module or two but you can have a look under /lib/modules/`uname -r`/kernel/drivers/usb (note the backticks, these mean it will work regardless of the kernel you have installed)
-
Thanks for answer,
I use qtopia 1.5.4
Casco 1.23 (Nastya)
Kernel 2/4/20
I`m newbie and dont know some things, how can i load a module and where i can get it. And also how can i look /lib/modules/`uname -r`/kernel/drivers/usb, where i should put in this phrase
Regards,
Dmitry
-
I`m newbie and dont know some things, how can i load a module and where i can get it. And also how can i look /lib/modules/`uname -r`/kernel/drivers/usb, where i should put in this phrase
that would be in a terminal, but give me a sec and i will look on my pc as to which module you should load
...
....
.....
ok on the command line/terminal type "modprobe usbserial"
if you dont have the terminal installed (i am sure cacko shipped with one) then there should be an ipkg on the CD you can install
i hope your laptop isnt a windows machine or else it will get harder from here on
next we need to know which mobile phone company you are with, this is the case if the networking panel dosent allow you to make a "dial up" connection, it may allow you to but we also might have to give it some more infomation