OESF Portables Forum

Everything Else => Zaurus Distro Support and Discussion => Distros, Development, and Model Specific Forums => Archived Forums => Sharp ROMs => Topic started by: steelmole on September 03, 2006, 11:38:28 am

Title: I Don't Have /etc/pcmcia/wlan-ng.conf
Post by: steelmole on September 03, 2006, 11:38:28 am

Should I make one?  I'm trying to add various lines to it as per this page:
https://www.oesf.org/index.php?title=Wireless_Card_Support (https://www.oesf.org/index.php?title=Wireless_Card_Support)

Also the command # kill -HUP `cat /var/run/cardmgr.pid` doesn't seem to work.

Title: I Don't Have /etc/pcmcia/wlan-ng.conf
Post by: ldrolez on September 03, 2006, 02:45:59 pm

It depends on your distribution and you wifi card. If you have a prism based card, you only need hostap_cs.conf.

Title: I Don't Have /etc/pcmcia/wlan-ng.conf
Post by: steelmole on September 10, 2006, 09:38:02 am

My distrobution is cacko 1.23, my wifi card is sitecom and only seems to work with openzaurus.  I do not know if it is prism.

Title: I Don't Have /etc/pcmcia/wlan-ng.conf
Post by: speculatrix on November 19, 2006, 04:42:06 pm

you still need the wlan-ng.opts, as these ARE used by cacko, because I think that hostap was not in original sharp rom, and Mas added hostap and to keep the network applet his scripts use the wlan-ng.opts to get started.

so, set up network options in QT gui, and it will create the wlan-ng.opts.